Splitter Diffusers
No reviews
/
Tax included.
Shipping calculated at checkout.
Need up to 2x more downforce to balance a GT Style wing?
Our Modular Splitter Diffusers are available to suit all splitters and applications as a cost effective solution to add much needed front end downforce.
Aero balance should be similar to your vehicle weight distribution with aobut 10% more rear bias. Please select accordingly or contact us for a recommendation
-
Small to balance a small-medium GT wing, Comes Printed in temperature resistant material, up to 30% downforce upgrade for the budget minded build.
Intended to be reinforced and moulded in or may break over time or used as a test piece for finding your aero balance.
12 degrees AOA
Comes with adjustable covers for downforce adjustment. Can be combined with Curved Small for more downforce.
-
Medium to balance a Medium-Large GT wing whilst being drag efficient, cannot be combined with other Diffusers. Comes in Carbon Fibre
10 Degree AOA -
Large for high down force applications. Comes in Carbon Fibre
13 Degrees AOA -
Curved Small for use in front of tyre to maximise available space whilst reducing tyre caused drag and turbulence. Comes in Carbon Fibre
12 degree AOA - EXTRA Large Combined setup consisting of Large and Curved Small to maximise downforce. Comes in Carbon Fibre
- Downforce adjustment brackets - Set of 4 threaded brackets to allow bolting on a Block off plate for downforce adjustment. Does not include Block off plate, please fab out of aluminium sheet and bend to suit the angles of your splitter.
Comes as a pair
Additional Notes
- It is highly recommended to increase fender venting with larger diffusers, this will see an increase in downforce. It is recommended to increase amount or size with each addition or increased size diffusers
- Diffuser trailing edge can be profiled to the wheel well for tyre clearance
-
WARNING with these tunnels installed ensure the splitter is mounted solidly to the chassis and not the bumper, they WILL rip off your plastic parts from the downforce generated. Additional mounting and reinforcement is recommended with 3D printed tunnels as the install will reduce stiffness across your splitter blade.